Either all xclipped blocks or xrefs (after being bound) in a drawing can be cleaned or you can clean them one by one.

With XClipClean you can clean your xclipped blocks from everything that is outside the boundaries of the block.

Start with the command XCC to clean a selected block. You will then be prompted to select a block that is xclipped. The block will be saved to a temporary file during this process.

Use the command XCCAB for XClipClean All Blocks.

To do the cleaning without exploding nested blocks use the XCC1 or XCCAB1 commands.

The installer that ran when you downloaded this app from Autodesk App Store will start installing the app. Or, double-click the downloaded installer to install the app. You may need to restart the Autodesk product to be able to run the app.

To uninstall this app, exit the Autodesk product if you are currently running it.

On Windows 11 and 10 version 1703 or later press Windows+I on the keyboard to access Settings or click or right-click the Windows Start button and then select Settings. Click on Apps (optionally followed by Apps & features). On older Windows versions click Control Panel > Programs > Programs and Features or Control Panel > Add.

Support for AutoCAD 2017 and older is available by contacting JTB World directly.

XClipClean was built to solve some specific requirements and thus there are cases where XClipClean does not work well or at all. Nested clipped blocks are not handled. Inverted clipped blocks are not handled. It might be possible to modify the code to handle these cases but the work might be more than the gain.

Hatch trimming is not supported.

SDI set to 1 is not supported. SDI must be set to 0.

The HIGHLIGHT variable may be set to 0 if the app fails and you need to restore it to 1 manually.