Avoid MEP clashes

Avoid MEP clashes



Plugin for Autodesk® Revit® to resolve clashes in MEP systems (Pipes, Ducts, Cable Trays, and Conduits). The plugin allows you to adjust many parameters and find clashes in elements in the host and linked models.


Main features of the plugin:

  • You can select the main elements in the host or in linked models or can combine them from both.
  • It works with any types of Pipes, Ducts, Cable Trays, and Conduits.
  • It saves insulation and lining for Pipes and Ducts.
  • It saves all parameters from the source element and you can select to copy or not mark the value.
  • You can select any offset between the main element and clashed with the MEP element.
  • You can select any angle of tracing between 1 and 90 degrees.
  • All last-used settings are saved.
  • The app works in 3D and Plan/Section views.
  • The app works with millimeters and inches.

체험판 설명

A fully functional version is provided for 7 days. To activate a trial license upon first launch, enter your email, read and accept the terms of use and request a trial. The trial license will begin to operate immediately after the request.

이 버전 정보

버전 2.0.0, 2024-01-24
Updated application interface.

스크린샷 및 비디오

고객 리뷰

4 리뷰
기술 도움말 보기
  • where can you get the full version?
    Carlos Omar | 3월 23, 2024

    And if I want the full version, how do I pay? and how much?

    Nikolai Basalaev (게시자) | 3월 26, 2024

    Thanks for your interest in the plugin. Just click the trash can icon next to the “license status” line. Or use the link: https://www.basalaevn.com/product-page/avoidmepclashes-revit

  • A must have!
    Carlos Pinto | 3월 01, 2024 다운로드 확인 (이것은 무엇입니까?)

    Very simple interface, speed up work flow! Good comunication with developer.

  • Bad
    TAIS NASCIMENTO | 8월 07, 2023 다운로드 확인 (이것은 무엇입니까?)

    Bad, out of ten attempts to use the plugin it only works in one. I contacted the developer and got no response.

    Nikolai Basalaev (게시자) | 8월 08, 2023

    Good afternoon. I didn't find any messages from you about the problem. Can you please write again and describe the problem? Thank you

  • Nice job!
    Sergey Zhebelev | 8월 02, 2023

    Good plugin. In Revit 2022 for confirming your choice you need to press "Esc"

맨 위로 이동