Composite Beam Design Extension 2016

Composite Beam Design Extension 2016

Autodesk, Inc.

Digitally signed app


System operacyjny:


Using this application, you can quickly check and design the behavior of composite beams, or design the whole composite floor system on a floor-by-floor basis within a single Autodesk Robot Structural Analysis Professional 2016 model.

You can also use the application to design non-composite steel beams.

The design is performed according to the ANSI/AISC 360-10 code.

Using the application allows full bidirectional integration with Autodesk Robot Structural Analysis Professional 2016.

Przeczytaj dokument pomocy

Informacje na temat tej wersji

Wersja 2016.1, 2018-10-12

Composite Beam Design update:

  • Fixed issues with slab analysis on module opening
  • Fixed issues in geometrical check of beam arrangement

Zrzuty ekranu i nagrania wideo

Recenzje klientów

(2 recenzje)


Pomoc techniczna
  • extensions not on ribbon
    Remi Tembo | stycznia 30, 2016

    Hi I downloaded timber framing and composite beam extension but this does no appear on the add-ins. I am using a student version of Revit 2016 How do I get to use the extension

  • Help with this app
    David Palomino | grudnia 13, 2015 Sprawdzone pobranie (Co to jest?)

    Already installed the app and Service Pack 1, but I still dating error. "None of the selected members could be designed" help please!

    Andre Ferreira | marca 01, 2016

    hi..i have the same problem. how did you resolve it?

    David Palomino | marca 04, 2016

    Hi, that problem ocurred because the app only function with sections W from american code. I recommend that you use only this sections.

    Ali Farag Anwer | marca 16, 2016

    I have the same proplem

    Pawel Czepiec | kwietnia 29, 2016

    Hi, On module start you should select a slab and at least 1 beam supporting this slab to open the extension. Below some additional rules: - Only wide-flange shapes (W-Shapes) can be designed. They are available in the AISC 14.0 (American hot rolled shapes) database you need to select in Robot before you open the extension. - Non W-Shapes (such as Channels) can be selected if they bear on beams to be designed. They are not designed but they are used to determine load on the designed beam. - Anything in the selection other than beams is filtered out automatically.

Przejdź do góry